The DM100 Disk Manager is an excellent solution for automated abrasive disk changing operations. The DM100 combines a disk change
time of less than 8 seconds with a capacity of 30 disks for efficient unattended operation. In addition, the DM100 can be fully
reloaded in less than 2 minutes without interrupting operation.
The DM100 is unsurpassed in ease of use and ease of integration
into your robotic work cell. A universal disk collet DC100 allows you to use the motor of your choice. The disk manager
is controlled completely through seven industry standard 24V digital control lines. Mount the DM100 to the floor, connect
air & electrical power, and installation is completed in a matter of minutes.
The DM100 disk manager is quite simply, the
fastest, most reliable, easy-to-use piece of equipment of its kind in the world.
Features:
- Storage capacity of 30 disks
- Disk change
time of less than 8 seconds
- Handles any mix of 4 - 7 in. diameter abrasive disks
- Handles any mix of abrasive disk media
- Stored disks
load from outside robot workspace
- Disks can be loaded during operation
- Single taught point for disk frop-off / pick-up
- Configurable
for robot approach from right to left
- Detects and warns of empty condition
- Universal disk collet mounts to any motor
- Universal disk
collet requires NO electrical or pneumatics
SPECIFICATIONS:
Electrical
Supply: 110 - 120 VAC, 60 Hz, 100 W
Interface: Standard 24 VDC digital
Control lines:
Inputs: Start, stop, change disk
Outputs: Ready, cycle complete, in position,
empty, error
Mechanical
Footprint: 14" x 63" (339mm x 1577mm)
Height: 95 in. (2407mm)
Pneumatic supply: Dry,
5m filtered
Non-lubricated, 100 psi (6.9 bar) min.
Collet motor mount: Customer specified
Specification subject to
change without notice
